New results with carbon fiber sleeves and solid mount barrel.

[KnifeMaker]

The Sun angle was terrible, and I couldn't see the screen on the camera at all GRRR!!


But here goes. LOL


the last pic is my way of being able to test a new barrel before being sent out  of an o ring install. Industrial Electrical Shrink Wrap. Red Neck engineering at its finest. LOL!    along with a poor boys scope stop. The M10-6 screws are doubled, as one is a locking screw in each of the screw lock down. I used one longer one in the real slot to but the scope ring base against in order to take advantage of the quick release rings. Kinda like not having to re site in every time I pull it.
 Next I will mill the breaches top for Picatinny slots. 

[KnifeMaker]

don't forget to click on the pic's to upsize.

[YEMX]

Slick set up!!

[KnifeMaker]

thanks tom. The industrial Heat Shrink wrap holds up for at least a thousand rounds without blow by. works much better than I had hoped.   Can only use it single shot though.


Making a single shot tray as soon as I can pick up a couple of the proper sized magnets.


Knife