Seneca Dragonfly muzzle diameter?

[2K1TJ]

Just got my Dragonfly in and was gonna put the ldc adapter from my cp1-m on it, but after removing the factory muzzle piece/front site, it was obvious that it isnt turned down as small as the cp1. I tried a Crosman ldc, but its a little too small. Still can't find my caliper, so I can't measure.

Anybody measured theirs yet?

[Jaycee]

If you intend to use an adapter on a none threaded gun it is very important to get one either made to fit or is a tight fit. Barrel sizes vary from gun to gun and a loose fit can cause problems with clipping and can damage an expensive LDC, so be careful just trying adapters from other guns on it, Neil.

[Sky]

I used a foredom tool to turn down the barrel. But it was about 20 thousandds bigger than a crossman barrel.

[Sky]

So I just went and measured. It was just behind the pressed in flares that hold the muzzle brake on. The ldc is on there permanently now. It was .462".

[Rob M]

should be .472 or 12mm

[Sky]

No it's .462. the end is turned down .010 about an inch and a half twards the breach after the muzzle brake impression.

[Rob M]

No it's .462. the end is turned down .010 about an inch and a half twards the breach after the muzzle brake impression.

that's good to know.. other barrels from that vendor are turned down to 10mm at the front and rear.

[Sky]

You can barely see the point they turn it down

[xtred1]

How loud is it with that on it?

[Sky]

How loud is it with that on it?

That's always a hard to tell kind of thing. I kinda judge on how loud it is compared to what it hits. So unless it's a Springer this one falls into the 100% category.

It's a TKO made for a crosman.

A puff is what you hear, and then hitting a wet log is much louder.

[xtred1]

I have a TKO on my 1322, but I have a dragonfly on the way. I was hoping it would fit the Dragonfly and make it just as urban friendly as my 1322

[Back_Roads]

 I am finding the crack of the DF to be a reward for pumping it 8 times, but I have other silent options to shoot.
 Good to know their are options on the market already though

[Rob M]

I am finding the crack of the DF to be a reward for pumping it 8 times, but I have other silent options to shoot.
 Good to know their are options on the market already though

not sure how the OP made this fit , .462 is substantially larger than the .436 tko brake

[Sky]

I am finding the crack of the DF to be a reward for pumping it 8 times, but I have other silent options to shoot.
 Good to know their are options on the market already though

not sure how the OP made this fit , .462 is substantially larger than the .436 tko brake

I'm not the OP but it was super simple. I used a foredom (like a dremel but way better) and a diamond Burr. I just covered the area with sharpie and removed the sharpie and repeated. It took a few hours, but the end result was "dang" near perfect.

[xtred1]

TKO makes one for a AriMax Varmint

[2K1TJ]

Thanks, everybody.