GTA
All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: AG72 on September 09, 2015, 01:02:45 PM
-
Hi folkīs! Can anyone of you Hatsan AT44 wood owners tell me the size of the middle stockscrew? The one thatīs hold the hole gunparts. In millimeters if possible, cause i lost mine after som maintenance... donīt ask me how, but itīs gone gone gone...
-
it is metric, i would say 5mm, but when you go do not stop at just that one screw, pick up extra like the barrel set screw and extra stock screws and o-rings while you are there...all metric
-
ok thanks! 5 mm, but how long is it? The quality of the screws are very poor, the heads are made of dried jam or somtething, worthles!
-
it is the exact same size of the screw inside the trigger guard just take that one with you.
-
ok! thanx a lot!
-
it is the exact same size of the screw inside the trigger guard just take that one with you.
Like walton said take one of the others with you. On my synthetic stock its the exact same size and length as the one behind the trigger and the one holding the barrel band.
-
it is the exact same size of the screw inside the trigger guard just take that one with you.
Like walton said take one of the others with you. On my synthetic stock its the exact same size and length as the one behind the trigger and the one holding the barrel band.
Yes i will do that, there must be some with better quality at the local hardware store