GTA
Airguns by Make and Model => Benjamin Airguns => Topic started by: OldFlyRod on September 08, 2015, 07:00:36 PM
-
My NP2 has been apart for a few weeks and I just got it back together. While it was down, I shot my .25 Marauder more than I had been, while fine tuning my NP2. The first thing I noticed going back to the NP2 was the major difference in the grip between the two guns and the effect it has on the trigger finger placement.
With a gun that has a wider grip I normally place the first joint of my finger on the trigger. Today after shooting a few sets with my NP2 and getting poor groups because of my inconsistent trigger pulls, I decided to to move to my second joint. This gave me a better feel and for me, a more consistent pull. My groups have tightened up considerably.
I was just curious if anyone else has had to adjust how they pull the trigger because of grip size.
-
Grip size has a whole lot to do with comfort, finger placement, and sideways torque when pulling the trigger. By the way, how is it shooting now? One reason I am looking to get a Steel Eagle.
-
It's feels good and is shooting as accurate as it has ever. Crosman Domes are averaging 720 fps. I missed shooting it while it was down. I'm looking for a machinist who will bore out the piston so, I can see how it will do with the N-Forcer GS. I needed to take a break from working on it for a while and enjoy shooting it as is.
For some reason, I had to put it on a press again to it get it back together. I was unable to use my Irwin Clamp.
-
I modified my clamp to work better. I narrowed the solid foot so that it will fit deeper between the forks. I remove the cross pin so the foot goes all the way in. Then on the screw foot, I cut a slot so that the web in the cap will fit and allow it to be as centered as possible. Works much better now.
-
I was lazy and didnt take the barrel off. The way my friend's press is set up, I can press it without putting pressure on the barrel.
I plan modifying my clamp before I take it down again, so I can get it done at home. Is your Irwin clamp the twist type?
-
I modified my clamp to work better. I narrowed the solid foot so that it will fit deeper between the forks. I remove the cross pin so the foot goes all the way in. Then on the screw foot, I cut a slot so that the web in the cap will fit and allow it to be as centered as possible. Works much better now.
Good idea. Can you post pics of the jaws?
I often mount mine in a B&D Workbench for stability.
-
Rod, it is the screw type with the wooden handle.
DOKF, I will try to post in the next couple days.
-
I finally took some pix. Sorry for the delay. Pay no attention to the rust on the clamp. It is a throw away. I narrowed the foot to fit between the forks. Remove the cross pin so that it goes in all the way.
https://goo.gl/photos/Y75tyjKJz9fLKTUf8
-
Ken, what did you cut it with?
-
I used a Dremel with a heavy cut-off wheel. An angle grinder with a thin wheel would also work, but would be harder to control.
How do you like the way it almost centers the clamp screw on the plug? Now I don't get even the slightest amount of torque slip as before.