GTA
Support Equipment For PCP/HPA/CO2 and springers ,rams => Support Equipment For PCP/HPA/CO2 => Topic started by: Dave19113 on June 27, 2015, 07:55:12 PM
-
Just ordered a regulator for my AT44 through Air Superiority..... Was reading the directions it states online.... It naturally says to empty out the air reserve. Is there a release valve to train the reserve that I dont see? Or should I just shoot the gun out til its empty?
Thanks in advance
Dave
-
You should have gotten a brass degassing part with the gun. It scrall the air. wrench to release ews on the air tube valve, you just use the large 4mm allen
-
You should have gotten a brass degassing part with the gun. It scrall the air. wrench to release ews on the air tube valve, you just use the large 4mm allen
I did receive a brass cap that screws on the end of the air reserve. Does anyone know of a video that describes it? I just dont want to do it in correctly...
-
Sorry my typing got screwed up. Just screw it onto the valve in. There should be a hole center. Just use a 4mm allen into the hole and turn it. Turn it slowly because there will be a loud hissing as the air is released.
-
Does it look like this?
https://www.youtube.com/watch?v=g1kIPwTbDQw (https://www.youtube.com/watch?v=g1kIPwTbDQw)
Cheers,
Smoketown
-
Sorry my typing got screwed up. Just screw it onto the valve in. There should be a hole center. Just use a 4mm allen into the hole and turn it. Turn it slowly because there will be a loud hissing as the air is released.
Ok much thanks....