GTA
All Springer/NP/PCP Air Gun Discussion General => European/Asian Air Gun Gates => Turkish AirGun Gate => Topic started by: vernongt on June 13, 2015, 06:13:34 PM
-
G'day Hatsan shooters,
Can anyone tell me where I can get some "shim washers" [VERY THIN], that I can use to shim UP the breech seal in my 125s?
I'd also like to do the same for my Benji Trail NP XL as well. :D
If you know that the same shim works in both rifles, I'd be delighted to know that too?
If I need to purchase them from a hardware store, could you tell me the sizes [OD, ID & thickness]?
Vernon
-
Most people use dental floss or plumbers tape under the o-ring.
If the o-rings are flattening out it may be time to replace them.
Local hardware stores or industrial sales are good choices.
On line at 'the o-ring store' if you want to buy cheap and in bulk.
I store my air guns 'broke' so there is no pressure on the o-ring.
(Not cocked, just the action disengaged from the detente.)
Cheers,
Smoketown
-
I bought a hole punch set that is used for leather for $13 on Amazon
You can make as many as you want and any thickness.I made some out of a coke can
Tom
-
Hatsan USA sells them
-
I bought Mylar flat washers at my local hardware store. They are thin and come in different ODs. The required ID can be produced with either a Dremel and a cone shaped grind stone or by using a hole punch. These washers can be made even thinner by rubbing them on 400 grit sandpaper. Works very well for me.
-
Crosman also sells them.