GTA

Airguns by Make and Model => Benjamin Airguns => Topic started by: DSMITTY on February 13, 2011, 01:29:38 AM

Title: NP XL 1500
Post by: DSMITTY on February 13, 2011, 01:29:38 AM

How do you take the action out of the gun? got the piston out cant seem to get the action out of the gun. the cocking lever seems to get in the way so u can't.
thanks for the help.

Title: Re: NP XL 1500
Post by: ezman604 on February 13, 2011, 01:45:07 AM

Did you pull the trigger group yet? One tip there for when you go to reinstall it, use a toothpick or jewlers screwdriver and lift the spring loaded sear lever and slide something under it to keep the sear up and out of the way. After everything is reinstalled, be sure to pull whatever you use to hold it up.
Now, to get the piston out, break the barrel while lifting the cocking lever linkage. You won't have to break the barrel too far to get the cocking lever shoe tilted to where you can lift it out of the slot. Reclose the barrel and flip the cocking lever back out of the way. Use a screwdriver or other flat item to push the piston back and out of the chamber.
When reinstalling the piston, be sure to use the soda can trick I posted to save the seal from damage by the threads.
http://www.gatewaytoairguns.org/GTA/index.php/topic,715.0.html (http://www.gatewaytoairguns.org/GTA/index.php/topic,715.0.html)

Enjoy the adventure and keep us posted.
Happy Shooting!!!!
Dave
 8)

Title: Re: NP XL 1500
Post by: DSMITTY on February 13, 2011, 03:23:55 AM

thanks i am going to order the new seal and put it in. did it seem to help any?

Title: Re: NP XL 1500
Post by: ezman604 on February 13, 2011, 10:56:29 AM

Well, my XL1500 cranks out about 24fpe. I'd say YES. All 3 of my Benjis had dinged up factory seal when I tore into them. A Maccari (or even a new factory seal) will most likely improve the performance. Sure can't hurt.
:)
Make sure you do a good debur, crosshatch and lube.

Title: Re: NP XL 1500
Post by: DSMITTY on February 13, 2011, 10:12:03 PM

i will def do that do you lube the grs kit or would you put moly grease on it? also would you put moly in the hatch part also?

Title: Re: NP XL 1500
Post by: uncle paulie on February 14, 2011, 09:08:36 AM

I lubed the outside of the GRS bushing, as per instructions. And yes, I moly the inside of the hatched compression chamber, but then wipe virtually all of it off. A small amount of moly is then put on the outside of the seal just prior to re-assembly. I normally experience one or two detonations initially afterwards, but little deiseling after that and almost no smoke.

pv  

PS. As far as the action goes, you can also remove the e-clip and spring holding the bear trap and remove it that way as well if for some reason you are not removing the barrel pivot bolt as well.