GTA

Airguns by Make and Model => Weihrauch Airguns => Topic started by: loiblb on March 14, 2015, 10:54:42 PM

Title: Vortec kit for the HW 95
Post by: loiblb on March 14, 2015, 10:54:42 PM
Where is there instructions on the Vortec kit for the HW95?
Thanks
Title: Re: Vortec kit for the HW 95
Post by: grauhanen on March 14, 2015, 11:23:17 PM
Quote from: loiblb on March 14, 2015, 10:54:42 PM
Where is there instructions on the Vortec kit for the HW95?
Thanks
The Vortek kit ought to have instructions.  For additional information google "tuning HW95"
https://www.youtube.com/watch?v=4f4MzG-UoBQ (https://www.youtube.com/watch?v=4f4MzG-UoBQ)
https://www.youtube.com/watch?v=7Ux0xVwUj54 (https://www.youtube.com/watch?v=7Ux0xVwUj54)

There is a lot of information available.
Title: Re: Vortec kit for the HW 95
Post by: loiblb on March 15, 2015, 12:56:43 AM
Will I need a spring compressor?
Better yet is there someone that installs?
Title: Re: Vortec kit for the HW 95
Post by: bReTt on March 15, 2015, 02:45:07 AM
Quote from: loiblb on March 15, 2015, 12:56:43 AM
Will I need a spring compressor?
Better yet is there someone that installs?

A spring compressor would be handy.  A long clamp would do with some soft wood cauls on each end.  I do my R9 and now 95 without a compressor but I use a clamp to add some slight pressure to get the 4 retaining tabs out of the rear of the receiver that that help hold the trigger block in place.  It's not difficult but if you are unsure or uneasy about it, someone out there will install it for you.  Just don't know who and it will add some cost to the project is all.