GTA

All Springer/NP/PCP Air Gun Discussion General => European/Asian Air Gun Gates => UK Airgun Gate => Topic started by: fishhuntmike on December 28, 2014, 05:43:21 PM

Title: Help with PG2 HO install
Post by: fishhuntmike on December 28, 2014, 05:43:21 PM

I just installed the Vortek PG2 HO kit on my tx200hc keeping the original piston seal and top hat, but removing the metal guide and washer from the trigger assembly.  Now the gun won't cock past two clicks on the bear trap mechanism and won't engage the sear to the best of my knowledge.

Just wondering if I did something wrong.  Any help or insight would be greatly appreciated!

Mike

Title: Re: Help with PG2 HO install
Post by: dynasuperglide on December 28, 2014, 06:35:59 PM

Check the Vortek site for the kit. It says NO tophat required. Sounds like you have too much stack up. Scott

Title: Re: Help with PG2 HO install
Post by: fishhuntmike on December 28, 2014, 06:45:05 PM

Thanks Scott.  You are right!

Now it works fine.

Mike

Title: Re: Help with PG2 HO install
Post by: dynasuperglide on December 28, 2014, 07:17:31 PM

Mike, Glad to help! Keep us posted on how you like it and how it performs. Peace, Scott