GTA

All Springer/NP/PCP Air Gun Discussion General => Air Gun Gate => Topic started by: coaxialtasko on July 26, 2014, 03:26:24 AM

Title: grt trigger for ruger blackhawk elite
Post by: coaxialtasko on July 26, 2014, 03:26:24 AM

how can i find out if one of the charlie da tuna triggers works in my ruger blackhawk elite,my e-mail isn't working right.

Title: Re: grt trigger for ruger blackhawk elite
Post by: ShakySarge on July 26, 2014, 04:15:40 AM

The GRT3 trigger is NOT compatible with that series of rifle, sorry.

Matt

Title: Re: grt trigger for ruger blackhawk elite
Post by: Blue on July 26, 2014, 06:58:50 AM

I think the Air Hawk/Blackhawk trigger is a copy of the Diana T05 trigger (which isn't bad).

There are mods out there to make it more adjustable with the addition of a second screw.  You may also want to talk to Mike Mellick at Flying Dragon Air Rifles, I think you can send him the trigger and have him work on it for you.

Blue

Title: Re: grt trigger for ruger blackhawk elite
Post by: martis880 on July 23, 2021, 03:43:54 PM

Quote from: Blue on July 26, 2014, 06:58:50 AM

There are mods out there to make it more adjustable with the addition of a second screw.

Blue

I've been on the hunt for instructions for this mod. Have you seen them anywhere?

Good tip about sending to Mike - that might be the way to go, was curious to see if anyone had done the mod themselves.

Title: Re: grt trigger for ruger blackhawk elite
Post by: Roadworthy on July 23, 2021, 06:00:18 PM

Second screw mod is pretty straightforward.  You remove the cross pin then drill and tap for a screw going through that location.  The T01 trigger has 2.5 mm adjustment screws as I recall.  The T06 trigger uses 3 mm screws.  I suspect the T05 is closer to the T01.

Title: Re: grt trigger for ruger blackhawk elite
Post by: martis880 on July 23, 2021, 06:04:00 PM

I see you replied to my new thread too, thanks!