GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: Tyrantblade on July 24, 2014, 05:26:50 PM

Title: what would you do for a mount/rings for an at44 qe
Post by: Tyrantblade on July 24, 2014, 05:26:50 PM
Scope for the time being is a 1 inch tube Hawke , mount/rings is the only thing to add to the cart and then check out.
Title: Re: what would you do for a mount/rings for an at44 qe
Post by: Gatorproof on July 24, 2014, 05:35:43 PM
I have always used  the Weaver type rings, they hold better then the Dove Tail groves,  imo.

Buy the best rings you can afford.  I use Amazon to avoid shipping costs and they have a huge selection.

Be Well,
Gator
Title: Re: what would you do for a mount/rings for an at44 qe
Post by: Tyrantblade on July 24, 2014, 05:57:10 PM
Just did 2 BKL rings (medium height even though low might have worked), should be probably Monday-Tuesday, just thought about the $10 for 10, but since I didn't do it before submitting order hopefully I don't need it.
Title: Re: what would you do for a mount/rings for an at44 qe
Post by: Gatorproof on July 24, 2014, 06:04:46 PM
Buddy,
$10 is aweful cheap for peace of mind. So at least you know it fires and at what fps and the rotary clip moves properly

Be Well,
Gator.
Title: Re: what would you do for a mount/rings for an at44 qe
Post by: Tyrantblade on July 24, 2014, 06:18:53 PM
Okay did 10 for $10, if only the Benjamin sold so I could of ordered 2 extra clips without being close to my limit, but a reload or two isn't the end of the world and 10 shot clip better than just 1 in the barrel.