GTA

Support Equipment For PCP/HPA/CO2 and springers ,rams => Support Equipment For PCP/HPA/CO2 => Topic started by: nomobux on July 04, 2013, 04:42:25 PM

Title: Hill pump assembly
Post by: nomobux on July 04, 2013, 04:42:25 PM

  Ok. I give up.  These Hare & Tortoise pic instructions leave a lot of ?.  Do I use teflon tape on the fittings ( hose, dryer and adaptor ) and where does the RED washer in the packet go ?  Thanx

  Wow. Got a email from Hill / England in about 15 minutes.  No tape required and the RED washer goes on the air dryer fitting.

Title: Re: Hill pump assembly
Post by: gamo2hammerli on July 05, 2013, 10:55:28 AM

Amazing....didn't turn on the computer yesterday....so missed your thread.  Yeah, the red flat seal goes with the dry-pac container threads.

I use teflon tape with the hose and main tube threads (The one that screws into the body that have the gauge).  I had tried it without the tape and there were air leaks (Unless you screw them in really tight).  Just make sure the tape is not all the way to the end of the threads (You don't want some bits to break loose and go into your airgun's air chamber).

Title: Re: Hill pump assembly
Post by: nomobux on July 05, 2013, 11:09:38 AM

  Yeah, I figured on using tape. Thanx