GTA

Support Equipment For PCP/HPA/CO2 and springers ,rams => Support Equipment For PCP/HPA/CO2 => Topic started by: Raizer on June 28, 2013, 01:44:02 AM

Title: Setting Pressure on a JDS Regulator (rsterne I'm looking at you ;))
Post by: Raizer on June 28, 2013, 01:44:02 AM

So I've finally got a HPA tank coming for my QB, its a JDS Airman tank with a 1400psi reg on it.
Not sure I want to run it set that high so I was hoping rsterne or someone could share the different washer and shim set ups for different pressures?
I saw a post on a Drozd BB gun forum while googling that said rsterne had posted a whole heap of info on the Canadian forum, but the link was dead.

Title: Re: Setting Pressure on a JDS Regulator (rsterne I'm looking at you ;))
Post by: rsterne on June 28, 2013, 12:58:35 PM

Sorry, I don't have the data for a JDS reg.... all my work has been with Ninja regs....

Bob

Title: Re: Setting Pressure on a JDS Regulator (rsterne I'm looking at you ;))
Post by: Raizer on June 28, 2013, 08:15:17 PM

Sweet as Bob, I ended up finding the post on the Canadian forum where you went into detail on different configurations for your JDS reg anyway...

http://www.airgunforum.ca/forums/post206119.html (http://www.airgunforum.ca/forums/post206119.html)

Title: Re: Setting Pressure on a JDS Regulator (rsterne I'm looking at you ;))
Post by: rsterne on June 28, 2013, 08:39:05 PM

Wow, from 4 years ago.... I forgot all about it....

Bob

Title: Re: Setting Pressure on a JDS Regulator (rsterne I'm looking at you ;))
Post by: Raizer on June 28, 2013, 08:51:20 PM

Haha well thanks for the retroactive help! :)