GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: ogre8472 on March 01, 2013, 03:13:35 AM

Title: Leaking Prod 😪
Post by: ogre8472 on March 01, 2013, 03:13:35 AM

So over the week I thought I would have a chance to shoot some pests. But with a sales schedule and other things needing my attention it never had a chance. However in doing so I was able to notice my prod drop 1300 psi or so.
I am not about to tear down my favorite pcp with no knowledge of her working (seen to many accidents without proper training). Any recommendations on where to send her for diagnosis and repair?

Thanks all.

Gerry

Title: Re: Leaking Prod 😪
Post by: Rico14 on March 01, 2013, 10:41:59 AM

Check the air guage. It might be loose. If you take it off put some Teflon tape on it when you put it back in. If you want to send it out , search for Ronnie Easton. He's in Sacramento

Title: Re: Leaking Prod 😪
Post by: mtbdrew on March 01, 2013, 11:32:14 AM

Disco started doing the same thing. Turned out it was the fill port. Just needed cleaning and a little polishing as well as a new o-ring.

Title: Re: Leaking Prod 😪
Post by: Rico14 on March 01, 2013, 12:56:13 PM

The easiest way to check the fill port is to stretch a small ballon over it. If its leaking the ballon will start to fill

Title: Re: Leaking Prod 😪
Post by: Rescue912 on March 01, 2013, 07:24:47 PM

Mine always starts leaking around the gage. Degas it, retape it and see if that does it.

Title: Re: Leaking Prod 😪
Post by: ogre8472 on March 01, 2013, 09:03:24 PM

Thanks all. I will double check the purchase date and go that route if possible. I would rather Crosman repair it if possible. The gauge would be possible and I will check to foster fitting tonight when I get home.