GTA

All Springer/NP/PCP Air Gun Discussion General => Air Gun Gate => Topic started by: Berky on February 18, 2013, 08:58:31 PM

Title: P-Rod Hammer Spring
Post by: Berky on February 18, 2013, 08:58:31 PM

I have a .118 transfer port on the way. What would be an appropriate hammer spring upgrade and where would you get them? Thanks

Title: Re: P-Rod Hammer Spring
Post by: Norm_m on February 18, 2013, 10:43:48 PM

I used a Disco spring which is a bit longer and it gave me what I was looking for. More power and being able to fine tune it much better.

Norm

Title: Re: P-Rod Hammer Spring
Post by: Berky on February 19, 2013, 07:52:50 AM

I'm still fiquring out the internal operations of the P-Rod. Do you need to empty the pressure reservoir completley to change springs?

Title: Re: P-Rod Hammer Spring
Post by: Norm_m on February 19, 2013, 08:25:58 AM

No need to empty the reservoir. All you need to do is remove the air reservoir plug by removing one screw (located on the rear  of the trigger unit) on the bottom and two on the top (located on the top rear of the breech assembly) of it. Be sure to hold on to it as it may have a little spring tension on it
Norm

Title: Re: P-Rod Hammer Spring
Post by: Berky on February 19, 2013, 08:50:41 AM

Cool, thanks!