GTA

All Springer/NP/PCP Air Gun Discussion General => European/Asian Air Gun Gates => China/Asian AirGun Gate => Topic started by: dryanw on February 14, 2013, 03:45:39 PM

Title: QB disassembly ?
Post by: dryanw on February 14, 2013, 03:45:39 PM

Theres is no way to get at the hammer without removing the breach is there....? I really just need to remove the two washers I installed at the rear of the hammer spring.

Title: Re: QB disassembly ?
Post by: mikeiniowa on February 14, 2013, 08:09:11 PM

nope got to pull the reciever to do it...well maybe( i'm just thinkin here) you could pull the bolt handle and turn the bolt as far as it will go and pull the cocking block pin up far enough to get the cocking block out...never tried it and may not work..

Title: Re: QB disassembly ?
Post by: dukemeister on February 14, 2013, 08:21:59 PM

I was faced with the same dilenmma a few weeks ago, in the end just resigned myself to removing everything.
It takes only a minute or 2, but unfortunately if you have it scoped, it means re-sighting after.

Title: Re: QB disassembly ?
Post by: dryanw on February 15, 2013, 01:55:53 PM

Thanks for the input. We'll see what happens....