GTA

All Springer/NP/PCP Air Gun Discussion General => Air Gun Gate => Topic started by: Zelph on January 29, 2013, 10:17:17 PM

Title: TX200 improvement with Krytox GPL205 lube?
Post by: Zelph on January 29, 2013, 10:17:17 PM

Find it interesting to read of this Krytox lubricant and improved performance and possibly longer component life. What would I expect to see if I were to try it on a TX200?

What would I need to clean before lubing with this stuff?

Also, if I were to put in a new Vortek kit - would this lube provide any actual improvement over the stock/supplied lube?

A lot to ask but I am still quite new on this stuff. I tried searching but found more general discussion, so I ask here.

Title: Re: TX200 improvement with Krytox GPL205 lube?
Post by: OleTomCat on January 30, 2013, 02:28:23 AM

You use it just the same as the Moly lube on the seals and sliding surfaces.  As for what to expect it is just another lube, not a magic pill that will turn a terrible gun into a sweat shooter, that will not burn under any circumstances so there is NO dieseling so you don't have to be as careful about it getting on the compression side of the seal.....

It can also be used on any of the sliding parts that you would use regular grease on..