GTA
Airguns by Make and Model => Benjamin Airguns => Topic started by: Fisherdude on October 10, 2010, 09:40:28 PM
-
Today I backed out the grub screw that keeps the pivot bolt from turning and sure enough it was a little loose. I went ahead and pulled it apart and found that there is 0.010 in. clearance on each side of the barrel block. One side of the barrel block was bored a little deeper than the other and the factory plastic washers just weren't able to fill the gap. I went back with a 5/16 brass washer that was a few thousandths thicker and put her back together. Once again I am able to make my swingers spin at 30 yard. Yee Haw!!!
-
Yep, bronze or brass washers do the trick! Keep an eye on them also, as mine wore in as the shots added up. A little tightening of the pivot screw from time to time keeps my gun happy!
-
Don C sent me some bronze washers a while back. Thanks Don. I am in the proceess of doing a tune one a new Titan GP. The washers Don sent me worked out great.
I had to do a bit of work on them so they would fit properly. In the end I had a great setup.