GTA
All Springer/NP/PCP Air Gun Discussion General => Machine Shop Talk & AG Parts Machining => Wood Chop Shop (Working with wood) => Topic started by: howie1a on January 24, 2012, 12:22:21 PM
-
Hi here are some more pics of the stock we are making , we are making the slot for the cocking linkage and the inside clearances for the cocking linkage , as you know I use the old stock to transfer the places that make it possible to match the old stock. You will see that some of the cutouts have to be made with a table saw and some of the cutting is done with a router that I have made some changes to so it will do the job. In the pic,s 160 to 170 I am locating the holes for the forward screws in the stock I use some masking tape to mark where the top of the stock is and the center of the screws then transfer the location to the outside of the stock. The end pics show that the gun has been put into the stock and shot so we know all the cuts work and in this case no reliving of the stock was needed also I have put the yellow heart trim on and the butt pad after checking that the LOP is right I like about 13 3/4 " I will put more pictures in the post #4 since I can't get them all on this post. Howie