GTA
Airguns by Make and Model => Air Venturi Airguns => Topic started by: mwgm2020 on May 10, 2025, 07:19:28 PM
-
I've got a new Avenge-X Classic and the gauge will not read past 3K. This is the tank side not the reg side gauge. My SCBA tank and fill adaptor gauges are showing +4K PSI but the gun's gauge does not show past 3K PSI. I have filled the gun multiple times and the guns gauge will not go past 3K.
Any suggestions? I've emailed Pyramyd's CS with this issue and am waiting for a reply.
-
Yup new gauge should fix the issue.
-
Steven , just saw this post. As James said , a new gauge will probably solve the issue. I had a BSA (gauge) that went wacky , it looked as though it was almost
empty & would not register as the gun was refilled. One call to AOA and a new one was sent. Installed the new gauge & all good.
-
I've got a semi-funny story about this issue. I've been using an eBay fill adaptor for my 3K PSI guns. It has a bit of a leak from the vent valve. The Avenge-X is a 4300 PSI tank so I'm trying to fill past the usual 3K but that gun's gauge only showed to 3200 PSI each time I filled it. So, I figured the gauge has the problem. I just bought a Stickman SCBA fill adaptor and the first time I used it the fill the Avenge-X the gauge went up to 4K which is want the tank and Stickman gauges said was the pressure.
So, I guessing going past 3K using the eBay adaptor with the increased pressure was too much for the leak and it would fill the gun and stopped at 3.2K.
I let Pyramyd CS know what I found and apologized for taking up their time.
I have to say the Stickman is a really nice piece of equipment. You can even cascade fill from multiple bottles.