GTA

Airguns by Make and Model => Benjamin Airguns => Topic started by: wabo100 on May 09, 2025, 05:37:05 PM

Title: Sheridan C9 safety
Post by: wabo100 on May 09, 2025, 05:37:05 PM

I have a sheridan c9 f model I picked up it has the push pull safety the ball bearing was missing. Does anyone have any pictures of this setup I ordered some ball bearings and springs but it still doesn't operate correctly. Not sure they are correct I was told they were.

Title: Re: Sheridan C9 safety
Post by: Robert 5mm on May 09, 2025, 08:06:41 PM

If the Model F trigger assembly is the same as the Pump C9 - i have atteched the EVP diagram.

The Pump C9 does not use a spring and ball bearing for the safety ( the Crosman 1322/1377 does )

The push safety is held in with a wire coil.

Title: Sheridan F9 spring and ball
Post by: xcalibur on May 10, 2025, 11:39:03 PM

This should help

Title: Re: Sheridan C9 safety
Post by: wabo100 on May 12, 2025, 02:13:23 PM

Found out the ball bearing that the previous owner lost is 3mm was able to source it off of Amazon. Thanks for you help.