GTA
Airguns by Make and Model => Crosman Airguns => Topic started by: Methuselah on February 08, 2025, 08:10:17 PM
-
What power setting click stop do you shoot most, and what range are you zeroed?
Also bonus question ;D ;D ;D
With what pellets and what's the typical group size
-
I haven't shot mine in a while, but I use the high setting and turn it down with the hammer tension screw, it has a better trigger on high setting. With the hammer backed off on low setting it makes a little pop, very indoor friendly. It's zeroed at 25ish yds with CPHPs and shoots pretty good, but not as good as my P17 or 1322.
-
Thanks for chiming in Peter, I didn't consider that adjusting screw coming into play :D
I wonder what fps is in high with your adjustment?
So ok at 25. An inch?
-
I run mine on high power pretty much all the time. Usually shoot it at 10M. The low power setting is way too low unless shooting across a table. With no way to mount an optic and my shaky, old-man offhand skills, pellet choice is pretty much irrelevant.
-
Thanks for chiming in Peter, I didn't consider that adjusting screw coming into play :D
I wonder what fps is in high with your adjustment?
So ok at 25. An inch?
I don't remember the high, but I opened up the ports in the valve and used a newer exhaust valve. I want to say it was around 480-490?
Groups were around an inch to inch and a half, iirc.
-
I run mine on high power pretty much all the time.
Thanks Ernie ... I'm not old enough to remember anything Eisenhower
did...
-
Thanks for chiming in Peter, I didn't consider that adjusting screw coming into play :D
I wonder what fps is in high with your adjustment?
So ok at 25. An inch?
I don't remember the high, but I opened up the ports in the valve and used a newer exhaust valve. I want to say it was around 480-490?
Groups were around an inch to inch and a half, iirc.
That's pretty good shooting for 25 yards
-
Don't hold me to it, my shooting is better than my memory!