GTA
Support Equipment For PCP/HPA/CO2 and springers ,rams => 3D printing and files => Topic started by: rsterne on December 24, 2024, 01:44:34 AM
-
I just finished up my .25 cal MRod Carbine, here is a photo....
(https://hosting.photobucket.com/3850df3c-b679-46ee-81eb-78df103b29a8/2ee9e728-b1ae-4aef-90a9-719e95c5e9a0.jpg) (https://hosting.photobucket.com/3850df3c-b679-46ee-81eb-78df103b29a8/2ee9e728-b1ae-4aef-90a9-719e95c5e9a0.jpg)
Now a close up of the stock, top view.... Note the adjustable butt-stock (shown in center position)....
(https://hosting.photobucket.com/3850df3c-b679-46ee-81eb-78df103b29a8/5cf385cd-0a10-454f-9c56-05d24c5e1eb4.jpg) (https://hosting.photobucket.com/3850df3c-b679-46ee-81eb-78df103b29a8/5cf385cd-0a10-454f-9c56-05d24c5e1eb4.jpg)
and the bottom view....
(https://hosting.photobucket.com/3850df3c-b679-46ee-81eb-78df103b29a8/f0b25c4e-b076-469a-b19a-77414a6164bb.jpg) (https://hosting.photobucket.com/3850df3c-b679-46ee-81eb-78df103b29a8/f0b25c4e-b076-469a-b19a-77414a6164bb.jpg)
It slides over a PRod trigger group, and the top is larger than my previous 2260/Disco versions, to fit the larger 1.25" OD MRod tube size.... I also raised the comb line level with the top of the main tube.... The forestock also slides over the tube, with a single 4-40 bolt to clamp is just in front of the trigger.... The larger clamp at the front uses four 8-32 screws to clamp to the 21mm OD carbon tubing I used as a shroud.... I uses Matter3D 10% CF-PETG and printed with a 0.6mm nozzle, using 0.3mm layers and a 0.9mm line width....
Bob