GTA

Support Equipment For PCP/HPA/CO2 and springers ,rams => 3D printing and files => Topic started by: Privateer on November 24, 2024, 02:02:35 PM

Title: Not a good thing!
Post by: Privateer on November 24, 2024, 02:02:35 PM

Woke up to this mess!
 :o

(https://i.imgur.com/60ggYHt.jpg)

Title: Re: Not a good thing!
Post by: Insanity on November 24, 2024, 02:10:11 PM

That's a new failure mode.

Title: Re: Not a good thing!
Post by: Privateer on November 24, 2024, 02:12:33 PM

Was printing a large ParaTrooper wing. That large a part should not have come loose but it did.
 :(

Title: Re: Not a good thing!
Post by: OldCrow on November 29, 2024, 03:03:53 PM

Yup, usually bed leveling is the issue.  That presumes the bed is clean and you've applied your favorite "sticky/release" compound.

Manually heat the print head and GENTLY remove.  Take your time.