GTA

All Springer/NP/PCP Air Gun Discussion General => "Bob and Lloyds Workshop" => Topic started by: cosmic on August 27, 2024, 01:26:38 PM

Title: BBT in .458
Post by: cosmic on August 27, 2024, 01:26:38 PM

Bob if you are not busy, how about a .458 bbt for my Texan 1in 20 twist.. I trust you more than produced slugs,,
                                         Ray (cosmic)

Title: Re: BBT in .458
Post by: Back_Roads on August 27, 2024, 08:12:05 PM

 This might be darn close ???  https://noebulletmolds.com/site/shop/bullet-moulds/458-460/htc459-300-rf-cb5/htc459-300-rf-cb5-2-cavity-gc/

Title: Re: BBT in .458
Post by: cosmic on August 27, 2024, 09:20:28 PM

Thanks Brother.. I have the 460-315-RF-AV3 4 Cavity GC.... I just like BBT's.. He puts a lot into each design...

Title: Re: BBT in .458
Post by: rsterne on August 28, 2024, 01:47:23 AM

There is an old BBT in .458 from NOE....  https://noebulletmolds.com/site/product-category/bullet-moulds/458-460/458-244-fn-ca4-bt/

The slugs I designed at NOE's request for the Texans never materialized, I don't know why....

Bob

Title: Re: BBT in .458
Post by: cosmic on August 28, 2024, 02:21:36 PM

Well that not worthy Bob !! I might have accurate molds do one for me if I had a drawing of yours..

Title: Re: BBT in .458
Post by: cosmic on September 17, 2024, 12:00:23 PM

 How about a drawing of it Bob..  I would like to check it out.. .458 Texan

Title: Re: BBT in .458
Post by: rsterne on September 17, 2024, 01:36:48 PM

Not a boattail, a gas-check style base, like all the other calibres I designed for the Texan.... Nose is semi bore-riding to ease chambering in the short Texan chambers....

(https://hosting.photobucket.com/albums/oo221/rsterne/NOE%20Other%20Bullets/.highres/457%20Texan_zps1uupcdnu.jpg) (https://hosting.photobucket.com/albums/oo221/rsterne/NOE%20Other%20Bullets/.highres/457%20Texan_zps1uupcdnu.jpg)

Bob