GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Big Bore AirGun Gate => Topic started by: supertech77 on May 08, 2024, 12:02:38 AM

Title: 45 caliper nock for DIY arrow making
Post by: supertech77 on May 08, 2024, 12:02:38 AM
Been long time since I posted, I have been doing a bit of shooting arrows from my 909's 45 calipers, Finally figured out the perfect nock to fit the 45 caliper, Without spending a lot, Here is what I used" A empty 9mm bullet casing a 0-ring and some super glue and a {8.9mm o/d 400 vane 22 inch carbon fiber arrows}  I purchased from AliExpress, At { YEZ Archery 001 Store}, fit snug to the spent 9mm casing with the O-ring [sized to YOUR 45 caliper barrel, Any gun range has plenty of used casings. spent $11.65 for 12 -22inch 400 vane carbon mixed tubes,  these work, maybe someone else would post if they have a better nock creation? Other than buying the arrows from venders at $99.00, Any ways good luck hope it works for you. too   8)




YEZ Archery 001 Store

YEZ Archery 001 Store
Title: Re: 45 caliper nock for DIY arrow making
Post by: Back_Roads on May 08, 2024, 08:18:52 AM
 I did find some rubber stoppers that work well for .50 cal. IIR on Amazon, another member posted the link in a discussion in air archery.
Title: Re: 45 caliper nock for DIY arrow making
Post by: supertech77 on May 08, 2024, 09:58:27 AM
The O-rings I use on the 9mm spent bullet casing, is #10, 1 in the groove with super glue, and 2 #11 glued at the point the shaft and casing meet, with 3  3 inch 400 vane fletching's. gives a vacuum when removed from the barrel by hand, I also put a # 11 O-ring at the front of the arrow behind the broadhead not glued for proper barrel alignment,    8), 
Title: Re: 45 caliper nock for DIY arrow making
Post by: supertech77 on May 09, 2024, 04:24:42 PM
Been long time since I posted, I have been doing a bit of shooting arrows from my 909's 45 calipers, Finally figured out the perfect nock to fit the 45 caliper, Without spending a lot, Here is what I used" A empty 9mm bullet casing a 0-ring and some super glue and a {8.9mm o/d 400 vane 22 inch carbon fiber arrows}  I purchased from AliExpress, At { YEZ Archery 001 Store}, fit snug to the spent 9mm casing with the O-ring [sized to YOUR 45 caliper barrel, Any gun range has plenty of used casings. spent $11.65 for 12 -22inch 400 vane carbon mixed tubes,  these work, maybe someone else would post if they have a better nock creation? Other than buying the arrows from venders at $99.00, Any ways good luck hope it works for you. too   8)

I think this post needs to be moved to Air archery gate,[ please.] Thanks, Moderator


YEZ Archery 001 Store

YEZ Archery 001 Store