GTA
All Springer/NP/PCP Air Gun Discussion General => BB Guns and Such => Topic started by: Ronno6 on April 16, 2024, 11:33:01 AM
-
A friend dropped off an old, all metal Marksman Repeater in pieces.....
I have found how to rrassemble, well almost.
The slide latck doesn't seel to have any visible means of keeping it in the receiver.
The pivot end had a hole that is tapered at its entry point, but I see no thereads inside the hole to indicate that there was ever a screw there.
The edge of the pivot lookes rough.......
This slide does not appear on any diagrams I have found.
It is a necessary component as the slide will not latched in the closed position in order to fire this beast.
Any knowledge will be appreciated...
-
There is a Youtube video on disassembly and reassembly of the Marksman repeater, in case you haven't seen it.
https://www.youtube.com/watch?v=H5qbEgnSZF0
-
Yup.
Thanks, tho.
The slide catch on the left side apparently is not intended to be removed.
It had enough of a bub sticking in past the receiver inside for me to press on a close fitting collar and JB Weld it into place.
Back together now and working to the best of its meager ability..........