GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Big Bore AirGun Gate => Topic started by: rsterne on April 10, 2024, 02:22:38 PM

Title: Printed Stock for .257 Condor
Post by: rsterne on April 10, 2024, 02:22:38 PM

I just 3D printed a new stock for my .257 Condor....

(https://hosting.photobucket.com/images/oo221/rsterne/Stock_Installed.jpg) (https://hosting.photobucket.com/images/oo221/rsterne/Stock_Installed.jpg)

The front of the stock fits inside the pistol grip and is glued to it (removable from the bottom with the original bolt).... The rear of the stock uses the stock tank clamp.... It is very rigid and the bottom is straight, flat, and parallel to the bore for shooting from the bench....

Bob

Title: Re: Printed Stock for .257 Condor
Post by: avator on April 10, 2024, 02:47:03 PM

Looks pretty solid... nice job.

Title: Re: Printed Stock for .257 Condor
Post by: luge007 on July 02, 2024, 11:19:30 AM

Beautiful work Bob (as usual)  How is it holding up so far?

Title: Re: Printed Stock for .257 Condor
Post by: rsterne on July 03, 2024, 01:33:01 AM

Haven't even shot it!....

Bob

Title: Re: Printed Stock for .257 Condor
Post by: cosmic on July 27, 2024, 04:48:31 PM

Extend it to a widened fore grip and achieve one solid rifle...Just got a Texan LSS

Title: Re: Printed Stock for .257 Condor
Post by: Baco on July 27, 2024, 05:09:35 PM

looks a lot with one i tried printing some time ago

couldn't get the bolt hole angle on the pistol grip right on the first try and not sure how to do it