GTA

All Springer/NP/PCP Air Gun Discussion General => Projectiles => Boolit and Pellet Casting => Topic started by: IMADMAN on March 27, 2024, 01:50:50 PM

Title: MP molds 8 cavity 6.42mm mold?
Post by: IMADMAN on March 27, 2024, 01:50:50 PM

Anyone try this mold yet?
READS- must be sized
50gr depending on lead mix
OAL- 10.6mm
If so what are you shooting them out of?
FPS and accuracy results?

Title: Re: MP molds 8 cavity 6.42mm mold?
Post by: 2A Georgia on June 25, 2024, 01:09:54 AM

I have the 5.55 mold drops at 35gr.  Shoots accurate groups out of my Notos and pp800r.  I slugged both barrels and they are not 5.52mm.  My only gripe is they are too log for either magazine but just fine for SST.  IIRC Notos was 21.5fpe with the plenum kit installed and the hammer 1 turn out.  They cast real easy.  I would assume if your barrel is 6.4mm these would be a great match