GTA
Support Equipment For PCP/HPA/CO2 and springers ,rams => 3D printing and files => Topic started by: WobblyHand on October 26, 2023, 08:58:10 PM
-
I did these a while back. These slide onto 1.5x1.5 80/20 extrusions. The 80/20 is mounted to the lathe backsplash. I also printed a 5 or 10 degree wedge for the 80/20 to keep the tool holders at a slight angle. I find these tool holders to be a real convenience. I print them in PETG, with 20% infill in 0.3mm draft mode. Have been using these for a year now and they have been holding up quite well.
-
Printing some more tonight.
-
Great idea, and seems like very functional prints!....
Bob
-
What I like about them is they slide along the 80/20 rail without too much effort, but they keep their place. Made my lathe tooling a little more organized. I just slid a new black one onto the rail from the left. Also made up the dead center holder on the far right end - same idea, but with a little reinforcement under the holder "shelf".