GTA
All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: darryl on November 06, 2011, 11:52:30 AM
-
Anyone know of the Disco air tube being a fit? How about the Mrod air tube?
thank you,
Darryl
-
Not sure of a fit to your question but I know a couple companies sell air tube extensions for the prod.
Dave
-
The Disco air tube is the correct diameter, but the holes are in a different place and/or more are needed.... The PRod breech bolt pattern (at least) is different.... I don't know if they are compatible or not.... The MRod air tube is larger in diameter and likely the holes are in a different place yet again.... AFAIK, there is no compatibility between any of them....
Bob
-
thanks Dave and Bob,
Jim Gaska is looking at an extension. I'm just investigating the possibility. I just saw that I could get 40 shots into the same POI with the stock setup I have now. So maybe more air would just be superfluous.
darryl
-
Shot count and power (FPE) are pretty much interchangeable.... More of one, less of the other....
Bob
-
So to preserve the shot count and the FPE I need to increase the volume of available air if I also want more of the former, and the latter. As i said somewhere, I now have the P-rod at 40 shots with a consistent POI (close in, so far), and 17FPE. So I ask myself: " is it ever enough?" Maybe I should concentrate on the Pneuma.
darryl
-
YUP, if you want more of both, you basically need a bigger reservoir....
Bob
-
Darryl, Still messing with the Pneuma. Time for an AA
-
Hi Gary,
Yep still dickin around with it. I could sell it as-is, but that would be passing on issues to someone else. Maybe after I can get it to where I feel good about it. I think I'm close. If I follow rsterne's teachings closely, I may have a pcp I can be proud of. If not, I'll probably sell it as-is and rob a bank (other way around) to finance an AA S500. Don't forget I already have a little AA (CZ S200).