GTA
All Springer/NP/PCP Air Gun Discussion General => Projectiles => Boolit and Pellet Casting => Topic started by: RonsPlc on October 07, 2022, 10:54:44 PM
-
I called NOE this afternoon to see when he was going to start production on the .22 Hunter 4 cavity again.
It turns out that it wasn't even in the lineup to be produced.
He put it in the lineup and told me that it would probably be 6-7 weeks out.
For those interested in it, maybe if you give him a call he'll bump it up a bit?
-
Ron I haven't posted on the NOE forum in a while now but maybe now its time that someone does because there's people that have been wanting the 217-17-WC wad cutter mold for quite a while now too.
I pretty much have all the molds that I want for now but anyone that's wanting a mold that's already been built before there's a spot in the forum where people can start requests on running molds.
I have been watching for the new .177 BBT mold that supposed to be coming out sometime but haven't heard anything about it in quite some time.
-
Ron I haven't posted on the NOE forum in a while now but maybe now its time that someone does because there's people that have been wanting the 217-17-WC wad cutter mold for quite a while now too.
I pretty much have all the molds that I want for now but anyone that's wanting a mold that's already been built before there's a spot in the forum where people can start requests on running molds.
I have been watching for the new .177 BBT mold that supposed to be coming out sometime but haven't heard anything about it in quite some time.
Pretty sure there is a thread for it. Need a few more to make the 10?