GTA
All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: thumbs on September 17, 2022, 01:37:39 PM
-
Does anyone know the size of the 0-rings that go on the inside of the quick connect foster fitting? thanks
https://www.pyramydair.com/product/air-venturi-compact-inline-filter?a=9038 (https://www.pyramydair.com/product/air-venturi-compact-inline-filter?a=9038)
-
-010 for a genuine Foster coupler but some of the global manufacturers use M2 x 6. The metric is ever so slightly fatter so when in doubt, try a -010 and if it won't seal you know you need the metric.
-
Does this look like the M2x6 O-ring? The -010 does not seal. This on is a bit fatter and smaller than the -010 I have used in other couplers in the past.
thanks again
-
Post a picture of that O-ring next to the -010.
-
Ok here are the O-rings.
-
I found a filter, seal set on line. My ? o-ring is different than the seal in the kit. I think, even though mine has been working, is probably not the right seals for the filter. The ones in the kit look like the -010 rings so I am guessing they are probably the m2x6 rings. Anyway we will see. I ordered some m2x6. Should be here tomorrow.
-
I’m guessing they are the same oring as any of the quick connect fittings we use?? I have not had to touch the orings in my av filter but these are what I use for any other quick connect I’ve changed and they work great. I get them at Home Depot.
-
Thanks. I'll keep that in mind. I got some o rings in today. The nice thing about it is they also sent a size sheet with the o rings. An exact size you can put over the paper to determine the size of the o ring you dealing with. Haven't used it yet though