GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: singleshotcajun on September 13, 2022, 10:34:20 AM

Title: Anyone install a regulator in a Umarex Origin?
Post by: singleshotcajun on September 13, 2022, 10:34:20 AM

My .22 Origin is two years old and still going strong. Just bought a Origin in .25 . I am digging my .25 Origin as a pester so much I canceled my order for Standard Airacuda in .25. I will likely revisit that when JTS has them in more of our hands. Less than three years from purchase Umarex will fix problems under warranty you pay shipping to and from Arkansas. I am thinking that when I do have a problem(hopefully after three years) I will remove the "everpressure" system and install a regulator if possible. I know there are many warnings of "if you disassemble this you will DIE ! " Lawyer stuff I reckon. What say you ?

Title: Re: Anyone install a regulator in a Umarex Origin?
Post by: jjohnsonlta on September 13, 2022, 11:30:59 AM

If you do Facebook there is a guy named Ray Barnett aka Kid Pellet that has done a lot of work with these guns. He has a YouTube video on the removal of the EPS. You'll probably answer all your questions by searching for some of his info.  I have PM him on FB and even talked to him on the phone. Hope this helps.

Title: Re: Anyone install a regulator in a Umarex Origin?
Post by: singleshotcajun on September 13, 2022, 11:43:09 AM

Thanks I'll check Youtube as I have managed to stay away from Facebook thus far.