GTA
All Springer/NP/PCP Air Gun Discussion General => Air Gun Gate => Topic started by: neric on August 30, 2010, 09:00:49 PM
-
Was noticing different, way off POI from the last time I shot my scoped RWS 92.
Go to move the elevation turret and it won't turn at all!!! >:(
THEN,,,,gracious,,,,I notice my scope is has moved back practically off the gun being held on by only one of the mounting posts :o
I just wasn't paying attention,,,,never had that happen before. My other scoped springers have a scope stop-pin hole. This gun does not have one. I figured I'll just cinch it down real good and use loctite on it.
My lesson is,,,,if a springer gun doesn't have a stop-pin hole,,,,,it ain't gonna have a scope on it.
Not only that,,,evidently my cheap Center Pointe wasn't rated for 'springers.' Its only good for bird watching now.
So I went to open sites and was getting practically one-holers at 15 yds.
This RWS 92 is a sweet little springer after I polished the trigger. It used to be the creepiest trigger I had ever used.
And I'm living happily ever after again. ;)
-
you can put a scope stop on that goes on the dovetails.
-
Unless you bought the scope used, it ought to have a warranty. Send it back. And, as low powered as the 92 is, it should have held up.
-
i thought all CP scopes are suppose to be springer rated
-
I can't remember where I came across this scope,,,,It may have come with the gun. The CRS (Can't Remember S@#%) syndrome comes to visit me sometimes.
Guess I'll look thru my records.
Actually it was a good thing for me with this scope failing. It somewhat forced me to use open sites and I realize I can do pretty darn good with them. I've been dependent on scopes perhaps too much.
-
you should still return it for another and at least have it on hand
-
What are you using for a scope mount? Are you using 2 piece or a one piece mount. Get a one piece with at least 3-4 bolts. If you ever take it apart for a tune then you can drill a scope stop hole at that time.
-
bkl has the one piece with 6 grub screws but they sre expensive
-
Buy a one piece mount and a scope from OpticsPlanet with free shipping. You can get a nice Tasco 3X9 AO Golden Antler for about $44.00 and a one piece 3 bolt mount for $15.00 all shipped for free.
I have that set up on a RWS93 that has NO scope stop. It's been tuned and has a more powerful spring (RWS320) and with a little finger nail polish the 3 bolt mount goes no were. There is also enough room on the mount to add 2 more bolt holes if your handy.
-
Yes,,,I did buy that scope from PA back in Feb '10,,,,yes it was a two piece mount that came with the scope,,,,and yes I am going to send it in for warranty.
Thanks guys,,,,had it not been for your promptings and pointers, I was just going to let it go
-
thats what we are here for :)