GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: thumbs on May 30, 2021, 07:39:06 PM

Title: Filling a 90ci Ninja carbon fiber tank
Post by: thumbs on May 30, 2021, 07:39:06 PM

I just go my compressor up and running.  I have filled the tank using the foster fitting on the side of the bottle and it works fine.  The question is can I fill the bottle using the fill whip connecting to the compressor with a double sided male fitting?  The reason I ask is the regulator I have on the Ninja tank is regulated to 2900psi out put.  My concern is pushing higher pressure air through the regulator in the opposite direction that it was intended to be used. 
thanks

Title: Re: Filling a 90ci Ninja carbon fiber tank
Post by: RichH on May 31, 2021, 09:10:09 AM

No, you can't do that.

Title: Re: Filling a 90ci Ninja carbon fiber tank
Post by: thumbs on May 31, 2021, 10:33:30 AM

Quote from: RichH on May 31, 2021, 09:10:09 AM

No, you can't do that.

Thanks  I didn't think so but I thought I would ask.