GTA

All Springer/NP/PCP Air Gun Discussion General => Projectiles => Boolit and Pellet Casting => Topic started by: lorka42 on April 18, 2021, 02:13:53 PM

Title: Hatsan piledriver molds
Post by: lorka42 on April 18, 2021, 02:13:53 PM

Looking for a .512-ish HP mold for my piledriver, it seems they are a bit like hens teeth... anyone have any suggestions, one for sale? looking for @380-450gr, its what my gun likes best..

Title: Re: Hatsan piledriver molds
Post by: sonnysan on September 09, 2024, 11:30:53 PM

I have a NOE mold that might fit the bill.

Title: Re: Hatsan piledriver molds
Post by: sonnysan on November 10, 2024, 11:37:24 PM

Just casted slugs from this mould yesterday. Tried with a .221 sizer. No resistance. They must be cast between .219 and .2050.

Title: Re: Hatsan piledriver molds
Post by: Back_Roads on November 11, 2024, 08:36:56 AM

 https://noebulletmolds.com/site/product-category/512/

Title: Re: Hatsan piledriver molds
Post by: maraudinglizard on November 11, 2024, 10:36:43 AM

I have the Umarex Hammer and use the accurate molds. I am between 320gr and 350gr. Mine is single cavity which makes it easier for me to hold when pouring and more consistent weight when casting. My slugs are solid. For hollow points, use Hollow Point Mold service. If not sure about buying molds, Bob Vogel has already got it figured out for air guns and you can buy slugs from him to try out before going down that rabbit hole.

https://accuratemolds.com/catalog.php?page=28#catalog-anchor

https://www.hollowpointmold.com/

https://www.mrhollowpoint.com/40-cal-to-50-cal.html#/