GTA

All Springer/NP/PCP Air Gun Discussion General => Air Gun Gate => Topic started by: Dave S on September 15, 2020, 10:33:43 AM

Title: Benjamin 267 problem
Post by: Dave S on September 15, 2020, 10:33:43 AM

The valve seat in my 267 has a crack in the valve seat and won't seal properly. I do have a scraped 262 which has a good valve. Does anybody out there know of someone who can swap out the valve?  De-soldering the valve is above my pay grade. Any advice or help would be greatly appreciated. Thanks, dave

Title: Re: Benjamin 267 problem
Post by: KevinJBrown on September 15, 2020, 12:43:52 PM

Welcome to the GTA Dave!

You might want to take a look around the forum see if you can find the information you're looking for or a place to start up a conversation about your 267.

Title: Re: Benjamin 267 problem
Post by: Wayne52 on September 15, 2020, 02:32:04 PM

Welcome to GTA Dave !!!

Title: Re: Benjamin 267 problem
Post by: Bentong on September 15, 2020, 06:28:53 PM

Welcome Aboard 👍🏽

Title: Re: Benjamin 267 problem
Post by: avator on September 15, 2020, 06:54:10 PM

Dave...
With well over 600 posts you are far from a new member.... lol
I'll move this thread to the PCP gate where it will get more traffic.

Title: Re: Benjamin 267 problem
Post by: eeler1 on September 16, 2020, 01:36:39 AM

Check with Tim at Mac-1, he’s the master of solder