GTA
All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: Piranhaboy on May 02, 2020, 10:51:36 PM
-
So I’m finally out of co2 carts. So I figured I would finally convert my 2250 to pcp. Well when I went to drill the valve the tape I put on my drill bit slipped up when I did the first hole and I managed to drill through into I think the throat (area on the non pressurized side of the seat). Any tips for sealing it up. I was thinking some red locktite?
-
Blue or low strength purple if you insist on sealing it...don't "really" need to as it'll only leak a small volume during the shot cycle. Try it and judge what's needed.
Al
-
Ok I’ve got it filled to 2300psi to leak check over night. I’ll see how it works tomorrow.
This is the 4th valve I’ve pinned and I was just being too cocky or something. Stripped the little breech screw, dropped the safety spring and ball, and then managed to nick every oring when I put it together.
-
Well it held air all night. It only leaks a small amount of air outta the screw I drilled through. But I threw the stock transfer port in and it’s not sealing worth a darn. Hopefully find my poly tube to replace the stocker.
My whole hope for this project is to make a gun that I can fill up with the last little bit of pressure in my tank before I get it filled.