GTA

All Springer/NP/PCP Air Gun Discussion General => Machine Shop Talk & AG Parts Machining => Topic started by: mtwolf13 on August 23, 2011, 06:27:22 PM

Title: Walther Falcan Hunter .22
Post by: mtwolf13 on August 23, 2011, 06:27:22 PM
I am looking for a parts diagram, (really the trigger,) For A Walther Falcon Hunter .22. Camo four screw stock. Any help would be appreciated.

John
Title: Re: Walther Falcan Hunter .22
Post by: shadow on August 23, 2011, 08:03:52 PM
I just updated my post for you and hope it help's if you have this trigger. (Shadow looking for schematic) post in this gate. Ed
Title: Re: Walther Falcan Hunter .22
Post by: mtwolf13 on August 24, 2011, 02:21:36 PM
Thanks Ed,

 Normally do my own tune work but it's been awhile. Flipped the trigger housing over and the pins went south along with the trigger parts. Careless on my part. I could figure it out, sooner or later trail and error, but a diagram would help the cause. Thanks again.

John
Title: Re: Walther Falcan Hunter .22
Post by: Pete on August 25, 2011, 04:12:03 PM
Quote from: mtwolf13 on August 23, 2011, 06:27:22 PM
I am looking for a parts diagram, (really the trigger,) For A Walther Falcon Hunter .22. Camo four screw stock. Any help would be appreciated.

John

what trigger has it got ?
Title: Re: Walther Falcan Hunter .22
Post by: mtwolf13 on August 25, 2011, 08:42:00 PM
Plastic trigger and another piece is plastic, Also has two small coill springs
Title: Re: Walther Falcan Hunter .22
Post by: Pete on August 25, 2011, 10:23:00 PM
this verson ?
The most common Hatsan trgger..
some have the smaller of the 2 coil
springs replaced with a hair clip stye spring..

the pics show the assembled order plus the
trigger mods for a much lighter pull...
the long spring at the rear can be replaced with
 a lighter one.. ball point pen spring works ok..

A longer screw in the trigger is also required as
with this mod the sear sits lower....
Title: Re: Walther Falcan Hunter .22
Post by: mtwolf13 on August 28, 2011, 11:57:21 AM
Pete,

First thank you! That's pretty much it. The only difference is in the third picture down, the piece shown with the red area removed, in my trigger, is a plastic piece..

John
Title: Re: Walther Falcan Hunter .22
Post by: Pete on August 28, 2011, 04:30:57 PM
Quote from: mtwolf13 on August 28, 2011, 11:57:21 AM
Pete,

First thank you! That's pretty much it. The only difference is in the third picture down, the piece shown with the red area removed, in my trigger, is a plastic piece..

John

I not seen the plastic sear trigger yet...
I would not do the mod to it..As the end could become
to flexable where the trigger blade presses against...
Title: Re: Walther Falcan Hunter .22
Post by: mtwolf13 on August 29, 2011, 08:53:34 AM
Pete,

Thanks again for the diagram. I am going to just polish the mating surfaces of the two metal parts, leave the plastic alone, bit of moly lube and that's it.

John