GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: UCChris on November 21, 2019, 07:53:27 PM

Title: SPA P15/Diana Skyhawk Regulator Questions
Post by: UCChris on November 21, 2019, 07:53:27 PM
My boss ordered a Diana Skyhawk and it leaked out of the box, so we had to pull it apart. When we pulled it apart, they forgot the snap ring in the regulator piston and it had come out. So I wondering what size of snap ring I need. Also, the washer stack fell apart and I put it back together as best I could, but I don't know the factory configuration. Does anyone know the factory stack configuration?
Title: Re: SPA P15/Diana Skyhawk Regulator Questions
Post by: miksatx on November 21, 2019, 08:27:50 PM
My boss ordered a Diana Skyhawk and it leaked out of the box, so we had to pull it apart. When we pulled it apart, they forgot the snap ring in the regulator piston and it had come out. So I wondering what size of snap ring I need. Also, the washer stack fell apart and I put it back together as best I could, but I don't know the factory configuration. Does anyone know the factory stack configuration?
So I've got a stock reg out of my Dominator that has the snap ring, piston and washers that was in the regulator out of my P-15. I just swapped them out. Snap ring should fit the Diana reg. Some where in my mess I got a huma reg I rebuilt that for some reason did work out. Not sure what I did wrong. Drop me a pm if ya want the stock reg. Freebie if ya want it.
Title: Re: SPA P15/Diana Skyhawk Regulator Questions
Post by: miksatx on November 21, 2019, 08:36:46 PM
This is what I had down for the washer stack.
Title: Re: SPA P15/Diana Skyhawk Regulator Questions
Post by: UCChris on November 21, 2019, 09:26:43 PM
This is what I had down for the washer stack.

That would be amazing! Thank you so much! Sending PM now.