GTA
All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: UCChris on November 18, 2019, 05:45:31 AM
-
I've searched and maybe my Google skills are off right now, but I can't seem to find the OEM dimensions of these two hammer springs. Can anyone tell me the length, OD, and wire diameter of these two springs?
-
13XX -- 1.950" Length -- 0.035" Wire -- 0.294" Diameter
22XX -- 2.015" Length -- 0.030" Wire -- 0.280" Diameter
(Both spec'd at 0.300" diameter)
-
13XX -- 1.950" Length -- 0.035" Wire -- 0.294" Diameter
22XX -- 2.015" Length -- 0.030" Wire -- 0.280" Diameter
(Both spec'd at 0.300" diameter)
Thank you!
-
I can provide dimensions of other Crosman springs that fit in these AG's if desired.
-
I can provide dimensions of other Crosman springs that fit in these AG's if desired.
If it's not too much trouble I would like to know this information? I have a couple Discos , 22xx and 13xx and this info may prove helpful in learning to tune them!
-
Crosman Hammer Springs Useful for 13XX and 24XX Applications.
Part Number Length Wire Used on
782-024 -- 2.015 -- 0.030 -- 2240/50/60, 2300T
2300A046 -- 1.935 -- 0.028 -- 2300S (with PA)
781A051 -- 1.950 -- 0.035 -- 1377, 1322, 2289
2200A032 -- 2.400 -- 0.036 -- 2100, 2200 Rifle
2261-009 -- 2.250 -- 0.035 -- Original Discovery Rifle
2261-A009 -- 1.642 -- 0.043 -- Challenger CH2009, Late Discovery Rifles
GBMP-009 -- 1.472 -- 0.047 -- Maximus, Full Power, Not Euro
1700-009 -- 1.500 -- 0.035 -- PRod
There are music wire springs 1.5" long of 0.040" wire and 0.042" wire available from outside sources that work well, but I do not recall where purchased.
Hope this is helpful and error free.
-
Thank you!
-
You can also get a 1.75" long x 0.040" wire spring of 0.30" OD from Trakar Spring in Ontario, Canada.... which is a great spring for a Disco.... although a bit hard to cock if you get greedy for power....
Bob
-
Thanks Bob, I may look into that one as well. This isn't for the 50+ fpe disco, I have another that I put together from all the parts outta that one. I want to try for efficiency and shot count on this one, once I get it put together I'll start another thread on it.
-
If you are after efficiency and shot count, I would suggest you look for a long, relatively weak spring and build an SSG for it.... The spring for a 2200, and a longer than usual end cap.... with a long spring guide to permit preload.... might be a good choice, depending on the power level you are after....
Bob