GTA
All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: perazzisc3 on November 07, 2019, 02:05:59 PM
-
received a new crown yesterday, started filling to 200 bar and noticed the reg gauge went up to 200 bar also HELP
-
Lower the reg according to the owners manual, take a couple shots every 1/4 turn. I believe clockwise lowers the reg.
If its not the newest amp reg then degas the gun. Remove the bottle then slowly back out the reg gauge to bleed the plenum. Give the reg adjuster a half or 3/4 turn once degassed. Should bring you close.
Or call the retailer for the best advice.
-
Lower the reg according to the owners manual, take a couple shots every 1/4 turn. I believe clockwise lowers the reg.
If its not the newest amp reg then degas the gun. Remove the bottle then slowly back out the reg gauge to bleed the plenum. Give the reg adjuster a half or 3/4 turn once degassed. Should bring you close.
Or call the retailer for the best advice.
Thank you for your help
I will give it a try, It is the amp reg.
what may have caused this?
-
Lower the reg according to the owners manual, take a couple shots every 1/4 turn. I believe clockwise lowers the reg.
If its not the newest amp reg then degas the gun. Remove the bottle then slowly back out the reg gauge to bleed the plenum. Give the reg adjuster a half or 3/4 turn once degassed. Should bring you close.
Or call the retailer for the best advice.
Thank you for your help
I will give it a try, It is the amp reg.
what may have caused this?
Not sure, i have an amp in my Impact and its very consistent so far. Love being able to adjust it up and down with pressure in the plenum.