GTA

All Springer/NP/PCP Air Gun Discussion General => Projectiles => Boolit and Pellet Casting => Topic started by: Airgunhunter73 on August 20, 2019, 06:04:52 PM

Title: NOE Mold HTC459-300 2 cavity
Post by: Airgunhunter73 on August 20, 2019, 06:04:52 PM

I picked this mold up for my Texan 45 thought it looked like a great boolit for deer and hog hunting, I'm using the deepest hp pin and it's dropping between 286-290 grain boolit. I tried it out last week got it dialed in and I then put 3 shots in bullseye at 25 yds moved to 50 first in the bullseye second shot it dumped the air tank not sure what the problem was other than it had been raining humidity was around 90% 70 degrees and I had a lot of condensation on the outside of the tank and shroud after shooting. I'll try again tomorrow or Thursday depending on the rain here's a couple of pictures of the boolits and the 25 yard target.
It's pushing the 286gr 1-928 2-845 3-816 from a 3600psi fill

Title: Re: NOE Mold HTC459-300 2 cavity
Post by: Loren on August 20, 2019, 09:41:32 PM

Nice looking bullets and looks real promising!!

Title: Re: NOE Mold HTC459-300 2 cavity
Post by: Airgunhunter73 on August 20, 2019, 11:42:19 PM

Thanks Loren I'll update my post as I get to try them

Title: Re: NOE Mold HTC459-300 2 cavity
Post by: gabi.nechita on August 21, 2019, 05:35:10 AM

I am also waiting for your 100m report.
Hope to do it well.