GTA
Airguns by Make and Model => Vintage Air Gun Gate => Topic started by: jackssmirkingrevenge on July 15, 2019, 01:27:38 PM
-
Does anyone have one of these?
(https://i.imgur.com/3O4OGNz.jpg)
I'm trying to find the typical velocity out-of-the-box
-
That looks nice. The metal looks a bit rough but not too bad. Is it smooth bore?
-
That looks nice.
Oh that's not mine, this is the one I acquired, it's complete apart from the front sight block that retains the barrel and the magazine tube:
(https://i.imgur.com/Mj4rWeK.jpg)
Stock:
(https://i.imgur.com/gM0dX5K.jpg)
Action assembled:
(https://i.imgur.com/x5pEuub.jpg)
Action disassembled:
(https://i.imgur.com/wbaA0Iv.jpg)
Action front showing the spring loaded detent that stops the BBs rolling out of the barrel
(https://i.imgur.com/4ipd4Ux.jpg)
Action showing the sear engaged in the hammer groove:
(https://i.imgur.com/ZI4Q6Pj.jpg)
Muzzle showing the rifled 4.5mm barrel, presumably this was intended for lead BBs
(https://i.imgur.com/wpedklb.jpg)
Rear sight:
(https://i.imgur.com/Lzs4ekZ.jpg)
Magazine tube lock, it appears the tube needs to be removed for loading:
(https://i.imgur.com/dIuLTDl.jpg)
Magazine follower:
(https://i.imgur.com/KlnB402.jpg)
Safety in the stock:
(https://i.imgur.com/KaI2Y1p.jpg)
Here is a cutaway of an example found online that shows the inner workings:
(https://i.imgur.com/HqwAGWx.jpg)
(https://i.imgur.com/oagOmW6.jpg)
It's a conventional hammer valve however the trigger is a double action that cocks then releases the bolt.
There is no bolt that seals the action, it's just the next BB in line that more or less blocks the breech.
The hammer spring tension can be adjusted by rotating the rear cap on the action, there is one white and one red mark.
If I understood correctly, the white mark is for filling because otherwise the hammer would keep the valve open.
The question now is what to do with it. Obviously a new front block needs to be made, but there's more that can be done.
I intend to run it on HPA, looking at the materials I should be able to take it to at least 2500 psi while retaining a significant safety factor.
The transfer port can also be opened up a little however I'll see what the performance is like just from the increased pressure and go from there.
-
finally found time to do some testing and an overview of the mechanism:
https://www.youtube.com/watch?v=JQ83CwXDkBc (https://www.youtube.com/watch?v=JQ83CwXDkBc)
-
Reuploaded footage:
https://rumble.com/v6ri19d-carabina-fionda-model-63-double-action-repeater-bb-gun.html