GTA
Airguns by Make and Model => Crosman Airguns => Topic started by: jccams on June 19, 2019, 08:10:57 AM
-
I installed a GRT III trigger in my Nitro Venom and after about 40 pellets it has developed a problem. When the rifle is not cocked it feels fine, it is under spring tension and not loose. When I cock it there is all of a sudden no tension in it's resting position, the trigger blade is very loose, it will flop around, it feels like it will fall out, hard to describe. However it still shoots and the safety still works but it is definitely not right and much different than it was. I have not pulled the stock off to see if there is anything obvious wrong. I am just wondering if anyone has experienced this or has any ideas of what may be going on.
-
I installed a GRT III trigger in my Nitro Venom and after about 40 pellets it has developed a problem. When the rifle is not cocked it feels fine, it is under spring tension and not loose. When I cock it there is all of a sudden no tension in it's resting position, the trigger blade is very loose, it will flop around, it feels like it will fall out, hard to describe. However it still shoots and the safety still works but it is definitely not right and much different than it was. I have not pulled the stock off to see if there is anything obvious wrong. I am just wondering if anyone has experienced this or has any ideas of what may be going on.
I've got that gun but not the upgraded trigger. I hope this works out for you. Have you sent a PM to anyone (Charlie da tuna) asking for insight?
Best of luck with getting this fixed,
Archie
-
I would pull the stock. The problem may be obvious because it's such a simple install.