GTA
All Springer/NP/PCP Air Gun Discussion General => Air Guns And Related Accessories Review Gates => Topic started by: beemangh950 on March 16, 2019, 05:54:56 PM
-
I’m looking for a good eye shade to help with eye relief for my RWS scope I have mounted on my Hatsan bt65, The UTG version reviews don’t look that good, A lot of the complaints were that it’s to hard.
-
Found quite a few on the bay. ;)
-
Bisley cups are the best.....
I could wear my glasses with it (does take some playing with to get it aligned the way ay need it)
-
Avoid the Discovery eye cups - they are total junk. Sightron makes a nice one. You just have to confirm if it will fit your scope. You may have to do some research to find out what diameters it will fit (or plan on using zip ties ::) )
-
Bisley cups are the best.....
I could wear my glasses with it (does take some playing with to get it aligned the way ay need it)
+1
-
Avoid the Discovery eye cups - they are total junk. Sightron makes a nice one. You just have to confirm if it will fit your scope. You may have to do some research to find out what diameters it will fit (or plan on using zip ties ::) )
I agree the discovery eye cups are junk. The cup is floppy piece of rubber, good luck trying to get it sealed around your eye so you actually see through it.
-
Avoid the Discovery eye cups - they are total junk. Sightron makes a nice one. You just have to confirm if it will fit your scope. You may have to do some research to find out what diameters it will fit (or plan on using zip ties ::) )
I agree the discovery eye cups are junk. The cup is floppy piece of rubber, good luck trying to get it sealed around your eye so you actually see through it.
EXACTLY! They are a total PITA to actually use - a waste of time.
-
I like how the shade keeps your eye in the right place less parllax. you can cut or what up with boiling water to shorted or stretch out a little.
-
I like how the shade keeps your eye in the right place less parllax. you can cut or what up with boiling water to shorted or stretch out a little.
What brand is that?
I've used UTG's, but you have to sand down the inside edge where it meets your face.