GTA

All Springer/NP/PCP Air Gun Discussion General => European/Asian Air Gun Gates => China/Asian AirGun Gate => Topic started by: Matchstickshooter on January 17, 2019, 08:50:47 PM

Title: Winchester 1100ss disassembly?
Post by: Matchstickshooter on January 17, 2019, 08:50:47 PM

Anyone had one of these apart?  Can you get to the spring/piston without taking the trigger all apart?

Thanks in advance!

Title: Re: Winchester 1100ss disassembly?
Post by: bhh on January 19, 2019, 12:57:25 AM

Quote from: Matchstickshooter on January 17, 2019, 08:50:47 PM

Anyone had one of these apart?  Can you get to the spring/piston without taking the trigger all apart?

Thanks in advance!

Going from memory here, but I think you can slide the trigger assembly back and pull it loose without  complete disassembly, but you have to gain access to that allen head bolt to get to the main spring.  I think that means removing at least one pin holding the trigger and removing the trigger.

First, remove the safety - the pin holding it in place slides out easlily.
Second, detach the spring connecting the anti-beartrap arm to the trigger assembly.
Third, loosen and remove the allen head bolt at the rear. I think this is where the trigger has to come out .
Fourth, slide the trigger pack back, down and out.

Then you should be able to remove the large pins holding the main spring assembly.

I think. It's been a while since I had it apart.

(https://photos.smugmug.com/photos/i-TC4qXn8/0/43e68160/X2/i-TC4qXn8-X2.jpg) (https://www.smugmug.com/gallery/n-Q9N2pc/i-TC4qXn8/A)