GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: Ironman482 on July 03, 2018, 12:37:02 AM

Title: Gauntlet barrel band
Post by: Ironman482 on July 03, 2018, 12:37:02 AM

I didn't care for the bottle to shroud stabilizer so I thought I would try to make a barrel band that attached to the bottle block, this was my first attempt at milling a part on my new to me smithy 3 in 1 machine ,I used 1 inch med rings and turned a bushing with a collar on one end for grub screws to adjust tension on the shrould. Haven't reassembled the rifle yet  need to cut a notch on the stock to clear the ring clamp .hope to finish tommorow

Title: Re: Gauntlet barrel band
Post by: Ironman482 on July 03, 2018, 12:50:57 AM

Pics failed to load, try again

Title: Re: Gauntlet barrel band
Post by: Jonah on July 03, 2018, 02:26:39 PM

Looks neat.  How is it working?

Title: Re: Gauntlet barrel band
Post by: Ironman482 on July 03, 2018, 03:07:36 PM

Got it back together and sighted in
Set it against the wall kinda rough,  picked it up by the barrel and then shot a mag ,still right on, think it's going to work well.

Title: Re: Gauntlet barrel band
Post by: Ironman482 on July 03, 2018, 03:10:33 PM

Over on the gauntlet owners site . Was told the New. 25 cal. Has a barrel band in the same place looks like umarex listens to customers complaints