GTA
All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: pageyjim on May 21, 2018, 01:18:38 PM
-
I am looking at different stock adapters and this one looks promising and was wondering if anyone has used it or have opinions on it. Thank you in advance. I am also looking at the RAI adapter but I am not concerned with aligning for cheek weld.
http://www.jsairrifles.com/P-Rod-AR-Stock-Adapter_p_24.html (http://www.jsairrifles.com/P-Rod-AR-Stock-Adapter_p_24.html)
-
I am looking at different stock adapters and this one looks promising and was wondering if anyone has used it or have opinions on it. Thank you in advance. I am also looking at the RAI adapter but I am not concerned with aligning for cheek weld.
http://www.jsairrifles.com/P-Rod-AR-Stock-Adapter_p_24.html (http://www.jsairrifles.com/P-Rod-AR-Stock-Adapter_p_24.html)
I have used the original one from Marmot Militia, and two versions of the RAI. The RAI are adjustable and can use medium scope rings. The MM was not, and needed high rings and was still rather "tight". Maybe a higher ring AR/co-witness type. But, I guess you are not concerned about that.
All the ones I have had, can loosen up over time. Not a big deal. Also, if you do frequent tuning changes the adapters need to be removed. Save the skeleton stock for those purposes.
-
I am looking at different stock adapters and this one looks promising and was wondering if anyone has used it or have opinions on it. Thank you in advance. I am also looking at the RAI adapter but I am not concerned with aligning for cheek weld.
http://www.jsairrifles.com/P-Rod-AR-Stock-Adapter_p_24.html (http://www.jsairrifles.com/P-Rod-AR-Stock-Adapter_p_24.html)
I own this one and it works great. You can still adjust the hammer spring if you unscrew the stock tube. If you get one don't forget about the small setscrew on the underside it stops the hammer setscrew from backing out. Use blue Loctite on it when you get it.
-
It looks like JSAR adapter incorporates the crosman end cap. ie no problem with the bolt loosening up over time.
-
It looks like JSAR adapter incorporates the crosman end cap. ie no problem with the bolt loosening up over time.
It sure does. It replaces the end cap.
-
I’m not a big fan of using aluminium or brass ,mostly due to my tinkering and disassembling the gun so often that the screw holes usually strip . I had a forum member make me one from steel and never has an issue with it .
-
Thanks for all the replies. I can't seem to make up my mind on which stock and adapter. There are pluses and drawbacks for all it seems and no clear choice that I can find.